JTAG cable for connection to a standard JTAG 20-pin 2.1.65 V to 3.6 V application voltage support on the JTAG/SWD interface and 5 V tolerant inputs.In addition to providing the same functionalities as the ST-LINK. The single-wire interface module (SWIM) and JTAG/serial wire debugging (SWD) interfaces are used to communicate with any STM8 or STM32 microcontroller located on an application board. JTAG/serial wire debug (SWD) specific features: The ST-LINK/V2 is an in-circuit debugger and programmer for the STM8 and STM32 microcontrollers.SWIM cable for connection to an application with pin headers or 2.54 mm pitch connector.SWIM cable for connection to an application with an ERNI standard connector Vertical connector reference: 284697 or 214017 Horizontal connector reference: 214012.ST-LINK V2 STLINK Debugging Emulator Download Programming Unit STM8 / STM32 Kit. SWIM programming speed rates: 9.7 kbyte/s in low-speed, 12.8 kbyte/s in high-speed 1 Set Of ST-LINK V2 STM8/STM32 Debugging Emulator Programmer STLINK Downloader.SWIM low-speed and high-speed modes support.1.65 V to 5.5 V application voltage support on the SWIM interface.support the full range of STM32 SWD debugging interface, a simple 4-wire interface (including power), fast. USB 2.0 full-speed compatible interface ST-Link V2 Programmer For STM8 and STM32.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |